Recreative sleep also on the way with your Jumpy II, Scudo II, Expert II or Proace I - the perfect supplement to your rear kitchen
The sleeping system Van can be built up with various seat combinations, regardless if without back seats, with a bench and/or the single seat or with both rows of benches (concerning long wheelbase). Thus you can use the bed flexibly depending on your situation.
In just a few minutes you can transform the passenger room of your van into a very comfortable place to sleep - using a cushy mattress that is made of excellent quality materials, you will be satisfied for a long time with it. You can easily use a fitted sheet for easy cleaning. The bed surface can be used by two persons with ease.
The sleeping module has a stable construction and its installation only takes a few twists. The vehicle does not need a fixed mounting or complex interior finishings. You do not have to change anything at your car
At home you just disassemble your sleeping system and put it into the garage or another shelter. This way your van remains an everyday vehicle that can be transformed into a camper as required.
While you are driving the sleeping system can be put into the boot and you can use your passenger´s room without restrictions.
Note wheelbases
- vehicle with short wheelbase (3000mm) - only possible with the front bench or without seats, sleeping system cannot be built up with the rear bench in the vehicle
- vehicle with long wheelbase (3122mm) - sleeping system can be built up with all seat situations (independently from the seats)
Please state when ordering (dropdown)
- year of construction
- wheelbase: short or long
- position of seats (if available), that are used in combination with the sleeping system
- vehicle lining: full lining, without lining
- additional support: if the bed is being assembled in connection with a two-seater bench, an additional support is needed instead of the single seat.
If you are not sure about the vehicle data, you can send us a picture of the opened boot of your van using the picture upload function or by email
Details
Assembly
The 2-part sleeping board can be hung up into the rear board and put on the folding brackets or rather on the folded seats. Then you just need to unfold the mattress above the area.
Material
poplar plywood with CPL coating (silver)
Weight
26 kg (sleeping system incl. mattress)
Total bed area
width 135 cm, length 188 cm
Scope of supply
2-part folding board
2 folding brackets
alternatively: supporting bracket if sleeping system is used in combination with 2-seated bench (choose in dropdown)
4-part COMFORT mattress: width 120-135 cm (narrowed in the back due to car lining), length 188 cm, height 10 cm