From your everyday Van to Camper within minutes- Recreative sleep with your T5/T6/T6.1 Transporter and Caravelle
Our sleeping system Van is perfectly suitable for Transporter/Caravelle with short wheelbase without 3-seater bench in the second row
It can be set up in just a few steps. in the first row you are flexible with the seats.
withour triple bench in the back (second row)
without any seats in the back
with one single seat and/or the double bench next to it, provided that it can be folded flat to the front (in combination with a support leg, see photo in the dropdown)
You remain completely flexible and can use the bed according to the situation. During the journey, the system rests in the boot. The passenger compartment and existing seats can be fully used.
optimal subdivision in the boot due to the rear board
foldable mattress can be stored on the rear board during the journey
addition of our rear kitchen is possible at any time
Additional support / bracket (when required please choose in dropdown)
It is possible to leave the 2-seated bench in the vehicle, you just need an additional supporting foot.
In the T6/T6.1 Transporter / Caravelle the single seat can also be folded and thus may stay inside the van. In this case you do not need any additional supporting foot.
Details
Assembly
Fasten the rear board in the boot of the vehicle using the original lashing strap eyelets.
Push the folding board forward, fix it to the rear board and fold it out.
stabilise with folding supports
Spread out the sleeping pad - done!
Total bed area / mattress size: width 143 cm, length 189 cm
Material: poplar plywood with CPL coating (silver)
Weight: 28 kg (+ mattress Comfort 12 kg)
Scope of supply
foldable rear board (height clearance under rear board 53 cm)
2-part folding board
2 folding brackets
supporting bracket (in case of existance of 2-seated bench) (choose in dropdown)
3-part mattress: width 143 cm, length 189 cm, height 10 cm (COMFORT)