Recreative sleep also on the way with your Berlingo / Partner
Minivan and still enough room for a two-person bed? Our VanEssa sleeping system uses the vehicle interior for the largest possible sleeping area without being dependent on remaining or dismounted back seats.
We choose the height of the sleeping system precisely in a way that the back seats may stay inside (but do not have to) and yet a comfortable distance between bed and vehicle roof remains.
The bedframe does not lie on the seats - thus the system can also be assembled without the seats - you can remove one or more seats out of the vehicle to create more storage room. While you are driving the sleeping system can be put onto the kitchen in the boot - all the back seats (if available) can be fully used.
In just a few minutes you can transform the passenger room of your minivan into a very comfortable place to sleep - using a cushy mattress. You can easily use a fitted sheet for easy cleaning. The bed surface can be used by two persons with ease.
The sleeping module has a stable construction and its installation only takes a few twists. The vehicle does not need a fixed mounting or complex interior finishings. You do not have to change anything at your car. At home you just disassemble your sleeping system and put it into the garage or another shelter. This way your van remains an everyday vehicle that can be transformed into a camper as required.
The sleeping system is being delivered in a way that you only have to fix it to the original mounting points in your vehicle.
It is also available in addition to our rear kitchen system. Attention If your Berlingo Multispace has the shelf for drinks on the backside of the middle back seat, the sleeping system only fits in the boot (storage in the boot) if you demount this cover or if the seat remains folded.
If you need help or our support in this manner, just contact us.
Details
Assembly
The rear board is being put into the boot, affixed to the original lashing eyes and fixated between the vehicle lining by adjusting screws. The folding board is hung up into the backside of the rear board and lies on a folding and a hanging bracket in the front. Finally you unfold the mattress over the sleeping board.
Material
poplar plywood with CPL coating (silver)
Weight
26 kg (+mattress Comfort 10 kg)
Total bed area / mattress size
width 115 cm, length 189 cm
Scope of supply
foldable rear board (clearance height under rear board 40 cm)
3-part COMFORT mattress
width 115 cm, length 189 cm, height 10 cm